Removing and installing components
NOTE: The images in this document may differ from your computer depending on the configuration you ordered.
Topics:
• Recommended tools
• Screw list
• Subscriber Identity Module (SIM) card
• Display assembly
• Solid-state drive
• WWAN card
• Speakers
• Rear Camera
• Microphone module
• Front Camera
• Kick stand
• Kickstand Hinges
• Docking connector
• Hall sensor daughter board
• Heat sink
• System fan
• Volume button daughter board
• Power-button board
• Fingerprint reader
• Battery
• System board
• Smart card reader
Recommended tools
The procedures in this document may require the following tools:
● Phillips screwdriver #0
● Plastic scribe
Screw list
NOTE:
When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE: Some systems have magnetic surfaces. Ensure that the screws are not left attached to such surface when
replacing a component.
NOTE: Screw color may vary with the configuration ordered.
Table 1. Latitude 5520Precision 3560 screw list
2
Removing and installing components 9
To Next Page
Loading...
