2. Remove the microSD card.
3. Remove the base cover.
4. Remove the battery.
5. Remove the speaker.
About this task
The following images indicate the location of the smart card reader and provide a visual representation of the removal
procedure.
Steps
1. Disconnect the NFC cable from the palmrest.
2. Disconnect the touchpad cable from the system board.
3. Disconnect the smart card reader from the palmrest.
4. Remove the three (M2x2.5) screws and slide the smart card reader out from its slot in the chassis.
Installing the smart card reader
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
44
Removing and installing components
To Next Page
Loading...
