About this task
The following image indicates the location of the smart card reader and provides a visual representation of the installation
procedure.
Steps
1. Slide the smart card reader into its slot in the computer chassis and secure it using the three (M2x2.5) screws.
2. Connect the smart card reader from the palmrest.
3. Connect the touchpad cable from the system board.
4. Connect the NFC cable from the palmrest.
Next steps
1. Install the speaker.
2. Install the battery.
3. Install the base cover.
4. Install the microSD card.
5. Follow the procedure in after working inside your computer.
Removing and installing components
45
To Next Page
Loading...
