Steps
1. Place the coin-cell battery into its slot on the system board.
2. Route the coin-cell battery cable back to the routing guides on the system board.
3. Connect the coin-cell battery cable to the connector on the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the WWAN card.
NOTE: This procedure applies only to computers shipped with a WWAN card installed.
About this task
The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.
36
Removing and installing components
To Next Page
Loading...
