Steps
1. Place the display assembly on a flat surface.
2. Slide the base assembly at an angle and gently press down on hinges to align the screw holes on the display hinges with
screw holes on the system board.
3. Replace the four screws (M2.5x5) that secure the display hinges to the system board.
4. Connect and peel back the camera cable and display cable on the system board.
5. Replace the two screws (M2x3) that secures the camera cable bracket to the system board.
6. Replace the two screws (M2x3) that secures the EDP cable bracket to the system board.
Next steps
1. Install the WWAN card.
NOTE: This procedure applies only to computers shipped with a WWAN card installed.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
Speakers
Removing the speakers for ultralight
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the WWAN card.
40
Removing and installing components
To Next Page
Loading...
