1. Fingerprint reader
2. Darwin 1 antenna cable
3. Darwin 2 antenna cable
4. P sensor connector
5. LCD connector
6. IR-camera cable connector
7. M.2 solid-state drive connector
8. Battery cable connector
9. Speaker 2
10. Fan connector
11. Clickpad FFC connector
12. WLAN
13. USH daughter-board FFC connector
14. Speaker 1
15. WWAN
NOTE:
For computers shipped without a WWAN card, a WWAN shielding cover and WWAN bracket is pre-installed to the
computer. As a result, follow the steps in the WWAN card removal/installation section to remove the WWAN shielding
cover and WWAN bracket before removing the system board.
CAUTION: Install the heat-sink after installing the system board as there are two screws (M2x3) underneath the
heat-sink, that secure the system board to the computer, that need to be installed first.
The following images indicate the location of the system board and provide a visual representation of the installation procedure.
Removing and installing components
51
To Next Page
Loading...
