Figure 13. Removing SIM card tray
Steps
1. Insert a pin into the release hole of the nanoSIM-card tray and push inward until the tray is released.
2. Slide the nanoSIM-card tray out of the slot on the computer.
3. Remove the SIM card from the nanoSIM-card tray.
4. Slide the nanoSIM-card tray into the slot, until it clicks into place.
Installing the nanoSIM-card tray
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the nanoSIM-card tray and provide a visual representation of the installation
procedure.
46
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
