Figure 34. Installing the battery cable
Steps
1. Connect the battery cable to the connector (BATT1) on the battery.
2. Route the battery cable through the routing guides on the battery.
3. Adhere the tape to secure the battery cable to the battery.
Next steps
1. Install the 3-cell battery or the 4-cell battery, whichever is applicable.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
Fan
Removing the fan
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
The following image indicates the location of the fan and provides a visual representation of the removal procedure.
Removing and installing Field Replaceable Units (FRUs)
67
To Next Page
Loading...
