Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Speakers
Removing the speakers for Ultralight
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the WWAN card.
4. Remove the 3-cell battery.
5. Remove the 4-cell battery.
About this task
The following image indicates the location of the speakers and provides a visual representation of the removal procedure.
Figure 39. Removing the speakers for Ultralight
Steps
1. Unroute the antenna cables from the routing guide.
2. Disconnect the speaker cable from the connector on the I/O daughter-board.
3. Peel the tape that secures the speaker cable to the palm-rest and keyboard assembly.
4. Note the speaker cable routing, and unroute the speaker cable from the routing guides on the palm-rest and keyboard
assembly.
5. Lift the speakers, along with the cable, off the palm-rest and keyboard assembly.
72
Removing and installing Field Replaceable Units (FRUs)