NOTE: Smart card reader is a replaceable component for the models with security configurations.
The image below shows the palm-rest assembly after the pre-removal parts procedures have been performed for any palm-rest
assembly replacement.
Figure 68. Removing the palm-rest assembly
Steps
1. For computers shipped with a carbon fiber palm-rest, use a fine-tipped instrument to push the nanoSIM outwards to remove
it from its slot on the palm-rest assembly.
2. After performing the pre-requisites, you are left with the palm-rest assembly.
Installing the palm-rest assembly
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the palm-rest assembly and provides a visual representation of the installation
procedure.
Removing and installing Field Replaceable Units (FRUs)
97
To Next Page
Loading...
