4. Tighten the screw to secure the SSD to the computer.
5. Stick the aluminum foil on the thermal plate.
6. Connect the battery cable to the connector on the system board.
7. Install the:
a. base cover
8. Follow the procedure in After working inside your computer.
Removing the display assembly
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover
3. Disconnect the battery cable from the connector on the system board [1].
4. Remove the:
a. WLAN card
b. WWAN card
5. To remove the cables:
a. Disconnect the camera and tune cable [1, 2].
b. Peel the aluminum foil until the folding line.
c. Remove the screws that secure the metal plate and lift it away from the computer [3, 4].
d. Peel the adhesive to access the display cable and disconnect it from the connector [5].
e. Disconnect the touch-panel cable from the computer [6].
22
To Next Page
Loading...
