Installing battery
1 Insert the battery into the slot on the computer.
2 Connect the battery cable to the connector on the system board.
3 Replace the M 2 x 4L screws to secure the battery to the computer.
4 Install the:
a base cover
b SD card
5 Follow the procedure in After working inside your computer.
PCIe Solid State Drive (SSD)
Removing the NVMe SSD card
1 Follow the procedure in Before working inside your computer.
2 Remove:
a MicroSD card
b base cover
c battery
NOTE
: You need not remove the battery, instead you can disconnect the battery cable from the system
board.
3 To remove the NVMe SSD card:
a Loosen the M2.0 x 3.0 screws that secure SSD thermal bracket [1].
b Lift the thermal bracket from the SSD card [2].
c Slide and remove the SSD card from the slot [3].
12
Removing and installing components
To Next Page
Loading...
