4. Install the WLAN card.
5. Install the SSD.
6. Install the memory.
7. Install the battery.
8. Install the base cover.
9. Follow the procedure after working inside your computer.
Power-Button Board
Removing the power-button board
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the memory.
5. Remove the SSD.
6. Remove the WLAN card.
7. Remove the heatsink-fan assembly.
8. Remove the power adapter port.
9. Remove the speaker.
10. Remove the display assembly.
11. Remove the system board.
1. Remove the two (M2x2.5) screws, that secure the power-button board to the palmrest assembly [1].
2. Remove the power-button board from its slot, in the palmrest assembly [2].
NOTE: Power-button board with Finger Print Reader (FPR), has a cable that disconnects from the system board.
Removing and installing components 81
To Next Page
Loading...
