3. Connect the speaker cable to the speaker board and reroute the speaker cable into its routing channel over the upper right
side of the battery.
4. Connect the battery cable to the system board.
Next steps
1. Install the base cover.
2. Install the microSD card.
3. Follow the procedure in after working inside your computer.
Heat sink
Removing the heatsink assembly
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the microSD card.
3. Remove the base cover.
About this task
The following images indicate the location of the heatsink assembly and provide a visual representation of the removal
procedure.
Steps
1. Disconnect the fan cable from the system board.
2. Remove the two (M2x2.5) screws on the fan case and the four (M2x2.5) screws (in reverse order, 4->3->2->1) that secure
the heatsink to the computer.
3. Lift the heatsink assembly from the computer.
32
Removing and installing components
To Next Page
Loading...
