3. To remove the LED board:
a. Disconnect the LED cable from the LED board [1].
CAUTION: Avoid pulling the cable as it would result in breaking the cable connector. Instead, use a scribe
to push the edges of the cable connector to release the LED cable.
b. Remove the M2.0 x 3.0 screw that secures the LED board to the computer [2].
c. Lift the LED board from the computer [3].
Installing LED board
1. Insert the LED board into the slot on the computer.
2. Tighten the M2.0 x 3.0 screw to secure the LED board.
3. Connect the LED cable to the system board.
4. Install the :
a. battery
b. base cover
5. Follow the procedure in After working inside your computer.
Smart card module
Removing smart card cage
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. base cover
24
Disassembly and reassembly
To Next Page
Loading...
