4. Remove the display bezel from the display assembly.
Installing touch display panel
NOTE: The touch display panel installation procedure is applicable only for systems with touch display configuration.
1. Place the display panel on the display assembly.
2. Reconnect the IR cable and eDP cable.
3. Replace the adhesive tapes and the Mylar shield.
4. Press the edges of the display panel until it clicks into the display assembly.
5. Install the:
a. display assembly
b. WLAN card
c. WWAN card
d. battery
e. base cover
6. Follow the procedure in After working inside your computer.
Display Bezel
Removing display bezel (nontouch)
NOTE: The display bezel removal procedure is applicable only for nontouch display configuration.
Disassembly and reassembly 33
To Next Page
Loading...
