1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. base cover
b. battery
c. WLAN card
d. WWAN card
e. display assembly
3. To remove the display bezel:
a. Use a plastic scribe to loosen the bottom edge of the display [1].
b. Loosen the tabs on the edges of the display [2].
NOTE: Adhesive is used to secure the display bezel to the display panel.
4. Remove the display bezel from the display assembly.
Installing display bezel (nontouch)
NOTE: The display bezel installation procedure is applicable only for nontouch display configuration.
1. Place the display bezel on the display assembly.
2. Press the edges of the display bezel until it clicks onto the display assembly.
NOTE: Adhesive is used to secure the display bezel to the display panel.
3. Install the:
a. display assembly
b. WLAN card
c. WWAN card
d. battery
e. base cover
4. Follow the procedure in After working inside your computer.
34
Disassembly and reassembly
To Next Page
Loading...
