Installing camera
The installation procedure is applicable only for systems shipping with a nontouch display configuration.
1. Connect the camera cable.
2. Insert the camera microphone module into the slot on the display assembly.
3. Affix the tape to secure the camera module.
4. Install the:
a. display bezel
b. display assembly
c. display hinges
d. display panel
e. WLAN card
f. WWAN card
g. battery
h. base cover
5. Follow the procedure in After working inside your computer.
NOTE: The two conductive tape pieces must be removed and then reattached when replacing the camera module.
38 Disassembly and reassembly
To Next Page
Loading...
