CAUTION: Only use a plastic scribe to disengage and release the clips with the prying motion along the edges of
the base cover. Do NOT use your fingers.
Steps
1. Loosen the eight captive screws that secure the base cover to the palm-rest and keyboard assembly.
2. Starting from the U-shaped indents near the hinges, use a plastic scribe to pry the base cover in the direction of the arrows
to release the base cover from the palm-rest and keyboard assembly.
CAUTION:
Do not pull on the base cover from the top side immediately after prying it open from the indents.
This will cause damage to the base cover. Continue with the steps described below to loosen all the hooks
that secure the base cover to the system before removing the base cover.
3. Firmly hold the left side and the right side of the base cover and remove the base cover from the palm-rest and keyboard
assembly.
4. Disconnect the battery cable from the system board.
Removing and installing components
17
To Next Page
Loading...
