Dell Latitude 9330 - Installing the M.2 2230 Solid-State Drive

Steps
1. Using a plastic scribe, pry open the solid-state drive shielding cover from the recess at the bottom edge of the solid-state
drive shielding cover.
2. Lift the solid-state drive shielding cover off the system board.
3. Remove the single (M2x2.5) screw that secures the solid-state drive to the system board.
4. Slide and remove the solid-state drive off the system board.
Installing the M.2 2230 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the M.2 2230 solid-state drive and provide a visual representation of the
installation procedure.
Removing and installing components
23