Steps
1. Align the notch on the solid-state drive with the tab on the M.2 slot.
NOTE: When replacing the system board, the thermal pad sticker underneath the solid-state drive must be transferred
to the replacement system board.
2. Slide the solid-state drive into the M.2 slot.
3. Replace the single (M2x2.5) screw to secure the solid-state drive to the system board.
4. Using the alignment post, place the solid-state drive shielding cover over the solid-state drive.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
WWAN card
Removing the WWAN card
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the SIM card.
3. Remove the base cover.
About this task
The following images indicate the location of the WWAN card and provide a visual representation of the removal procedure.
24
Removing and installing components
To Next Page
Loading...
