About this task
The following images indicate the location of the heat sink and provide a visual representation of the removal procedure.
Steps
1. Peel back the tape covering the orange WWAN-antenna cable(AUX3) from the bottom side of the CPU-shielding cover.
2. Peel back the foil from the top and bottom side of the CPU-shielding cover.
NOTE:
After peeling back the foil sheet from the top and bottom side of the shielding cover, pry open the cover using
the tabs located at its left and bottom corner to remove the cover from the system.
Removing and installing components 29
To Next Page
Loading...
