5. Remove the battery.
About this task
The following images indicate the location of the left speaker and provide a visual representation of the removal procedure.
Steps
1. Disconnect the speaker cable from the connector on the system board.
2. Peel back the adhesive tape that secures the orange WWAN-antenna cable(AUX3) to the system board.
3. Remove the orange WWAN-antenna cable from the routing guides along the system board.
4. Remove the single (M2x2.5) screw from the speaker and lift the left speaker from the computer.
Installing the left speaker
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the left speaker and provide a visual representation of the installation procedure.
Removing and installing components
37
To Next Page
Loading...
