WLAN-antenna module
Removing the WLAN-antenna module
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the SIM card.
3. Remove the base cover.
About this task
The following images indicate the location of the WLAN-antenna module and provide a visual representation of the removal
procedure.
Steps
1. Remove the single (M2x2.5) screw from the P-sensor bracket and remove the P-sensor bracket from the computer.
2. Remove the single (M2x2.5) screw from the WLAN bracket and remove the WLAN bracket from the computer.
3. Disconnect the green P-sensor cable, gray P-sensor cable, and the WLAN-antenna cables from their connectors on the
system board.
4. Remove the green P-sensor cable, gray P-sensor cable, and the WLAN-antenna cables from the routing guides on the
system board and the right speaker.
5. Remove the three (M1.6x2.3) screw that secures the WLAN-antenna module to the palm-rest and keyboard assembly.
Removing and installing components
41
To Next Page
Loading...
