6. Lift and remove the WLAN-antenna module with its cables from the computer.
Installing the WLAN-antenna module
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the WLAN-antenna module and provide a visual representation of the installation
procedure.
Steps
1. Align and place the WLAN-antenna module in the slot on the palm-rest and keyboard assembly.
2. Replace the three (M1.6x2.3) screws to secure the WLAN-antenna module to the palm-rest and keyboard assembly.
3. Route the green P-sensor cable, gray P-sensor cable, and the WLAN-antenna cables through the routing guides on the
system board.
4. Connect the green P-sensor cable, gray P-sensor cable, and the WLAN-antenna cables to their connectors on the system
board.
5. Place the P-sensor bracket on the system board and replace the single (M2x2.5) screw to secure it in place.
6. Place the WLAN bracket on the system board and replace the single (M2x2.5) screw to secure it in place.
42
Removing and installing components
To Next Page
Loading...
