Installing the power button
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the power button and provide a visual representation of the installation procedure.
Steps
1. Align and place the power-button assembly on the palm-rest and keyboard assembly.
2. Replace the two (M1.6x2.3) screws to secure the power-button assembly to the palm-rest and keyboard assembly.
Next steps
1. Install the system board.
2. Install the heat sink.
3. Install the battery.
4. Install the WWAN card.
5. Install the base cover.
6. Install the SIM card.
7. Follow the procedure in After working inside your computer.
Keyboard
Removing the keyboard
Prerequisites
1. Follow the procedure in Before working inside your computer.
50
Removing and installing components
To Next Page
Loading...
