NOTE: Do not dispose off the two pieces of graphite mylar. Reuse the two pieces when replacing or reinstalling the
keyboard.
4. Remove the thirty-seven (M1.2x1.3) screws and the single (M1.2x1.4) from the keyboard.
5. Lift and remove the keyboard from the palm-rest assembly.
Installing the keyboard
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the keyboard and provide a visual representation of the installation procedure.
Steps
1. Align and place the keyboard on the palm-rest assembly.
2. Replace the thirty-seven (M1.2x1.3) screws and the single (M1.2x1.4) to secure the keyboard to the palm-rest assembly.
52
Removing and installing components
To Next Page
Loading...
