Dell Latitude 9410 - Fan; Removing the Fan

1. Connect the battery cable
2. Install the base cover.
3. Install the SD memory card.
4. Follow the procedure in after working inside your computer.
Fan
Removing the fan
1. Follow the procedure in before working inside your computer.
2. Remove the SD memory card.
3. Remove the base cover.
4. Disconnect the battery cable.
NOTE:
For the system shipped with a WWAN card, there is an L-shaped bracket (P-sensor bracket) that covers the four
WWAN LTE antenna cable connections to the system board. The screw that secures the bracket to the system also
helps secure the fan to the system. Technicians must first remove the bracket before removing the fan and then
reinstall the bracket after the fan is reinstalled.
1. Peel off the Mylar sheet from the system board.
Removing and installing components
37