NOTE: The display assembly is a Hinge-Up Design (HUD) assembly and cannot be further disassembled once it is
removed from the bottom chassis. If any components of the HUD assembly are malfunctioning and need to be
replaced, replace the entire display assembly.
Installing the display assembly
1. Install the display assembly with hinges open at 180º aligned to the computer [1].
2. Replace the six (M2.5x3.5) screws [1] that secures the display hinges to the computer [2].
3. Connect the display cable [1] to the connector on the system board.
4. Close the latch [2] and adhere the tape on the display cable [3].
Removing and installing components
59
To Next Page
Loading...
