Removing the battery
1. Follow the procedure in before working inside your computer.
2. Remove the SD memory card.
3. Remove the base cover.
4. Disconnect the battery cable.
5. Remove the speakers.
1. Peel off the tape [1] and unroute the wireless antennae cables from the routing guides on the battery [2].
NOTE: The cables for the wireless antennas are routed over the plastic bracket at the top left corner and within the
routing channels along the left and bottom side of the battery. As a result, technicians must be careful when
unrouting the antenna cables from their routing guides while they are still attached to the wireless card. If there is
difficulty in unrouting the antenna cables from their routing channels, remove the WLAN card from the computer to
create space to unroute the cables.
2. Remove the single (M1.6x4.5) screw [1] in highlighted in red circle and four (M2x3) screws highlighted in yellow color that secure the
battery to the chassis.
3. Lift and remove the battery off the computer [2].
62
Removing and installing components
To Next Page
Loading...
