8. Stick the USH board cable [1], touchpad cable [2], and LED board cable [3] on the keyboard base.
1. Install the system board
2. Install the battery.
3. Install the heatsink
4. Install the speaker.
5. Install the fan.
6. Install the WWAN card.
7. Install the WLAN card.
8. Install the SSD.
9. Install the coin cell
10. Connect the battery cable
11. Install the base cover.
12. Install the SIM card
13. Install the SD memory card.
14. Follow the procedure after working inside your computer.
Palmrest assembly
1. Follow the procedure in before working inside your computer.
2. Remove the SD memory card.
3. Remove the base cover.
4. Disconnect the battery cable.
5. Remove the coin cell.
6. Remove the SSD.
7. Remove the WLAN card.
8. Remove the WWAN card.
9. Remove the fan.
10. Remove the speakers.
11. Remove the heatsink.
Removing and installing components
85
To Next Page
Loading...
