Screw list
NOTE:
When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE: Some systems have magnetic surfaces. Ensure that the screws are not left attached to such surface when
replacing a component.
NOTE: Screw color may vary with the configuration ordered.
Table 1. Screw list
Component Screw type Quantity Image
Base cover Captive screws 8
Solid-state drive M1.6x2.5 1
WWAN card Captive screw 1
System fan M1.6x2.5 2
Heat sink Captive screws 3
N/A
Display assembly M2.5x3 6
Removing and installing components 11
To Next Page
Loading...
