Steps
1. Align and place the base cover on the palm-rest assembly, and snap the base cover into place.
2. Tighten the eight captive screws to secure the base cover to the system.
Next steps
1. Install the SIM card tray.
2. Install the SD card.
3. Exit service mode.
4. Follow the procedure in After working on your computer.
Solid-state drive
Removing the solid-state drive
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the SD card.
3. Remove the SIM card tray.
4. Enter service mode.
5. Remove the base cover.
20
Removing and installing components
To Next Page
Loading...
