Steps
1. Peel the single piece of tape securing the system fan cable to the system board.
2. Disconnect the system fan cable from the connector on the system board.
3. Remove the two (M1.6x2.5) screws that secure the system fan to the palm-rest assembly.
4. Lift the system fan off the palm-rest assembly.
Installing the system fan
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the system fan and provides a visual representation of the installation procedure.
Steps
1. Align and place the system fan onto the palm-rest assembly.
2. Replace the two (M1.6x2.5) screws that secure the system fan to the palm-rest assembly.
3. Connect the system fan cable to the connector on the system board.
4. Adhere the single piece of tape securing the system fan cable to the system board.
Next steps
1. Install the base cover.
2. Install the SIM card tray.
3. Install the SD card.
4. Exit service mode.
5. Follow the procedure in After working on your computer.
26
Removing and installing components
To Next Page
Loading...
