Steps
1. Align and place the palm-rest assembly under the hinges of the display assembly.
2. Replace the six (M2.5x3) screws that secure the display assembly to the system.
3. Connect the display and camera cable to the connector on the system board.
Next steps
1. Install the base cover.
2. Install the SIM card tray.
3. Install the SD card.
4. Exit service mode.
5. Follow the procedure in After working on your computer.
Battery
Removing the battery
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the SD card.
3. Remove the SIM card tray.
4. Remove the base cover.
5. Remove the WWAN card.
NOTE:
If battery was disconnected from system board for service, there will be a delay during system boot-up as the
system will undergo RTC battery reset.
Removing and installing components 33
To Next Page
Loading...
