Steps
1. Peel off the adhesive tape securing the wireless antenna cables in place and unroute the wireless antenna cables from the
routing guides.
NOTE:
The cables for the wireless antennas are routed over the plastic bracket at the upper left corner and within the
routing channels along the left and bottom side of the battery. Technicians must be careful when unrouting the antenna
cables from their routing guides while they are still attached to the wireless card.
2. Remove the single (M1.6x3.5) screw and four (M2x3) screws that secures the battery.
3. Lift the battery from the left side of the system, and remove the battery from the laptop.
Installing the 4-cell battery
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the battery and provides a visual representation of the installation procedure.
Removing and Installing Components
37
To Next Page
Loading...
