Table 34. System setup options—Security menu(continued)
Security
UEFI Boot Path Security Controls whether the system prompts the user to enter the admin password (if
set) when booting to a UEFI boot path device from the F12 boot menu.
By default, the Always Except Internal HDD option is selected.
Table 35. System setup options—Passwords menu
Passwords
Admin Password Set, change, or delete the administrator password.
System Password Set, change, or delete the system password.
M.2 PCIe SSD-1 Set, change, or delete the NVMe SSD-1 password.
Password Configuration
Upper Case Letter Reinforces password to have at least one upper case letter.
By default, the option is disabled.
Lower Case Letter Reinforces password to have at least one lower case letter.
By default, the option is disabled.
Digit Reinforces password to have at least one digit number.
By default, the option is disabled.
Special Character Reinforces password to have at least one special character.
By default, the option is disabled.
Minimum Characters Set the minimum characters allowed for password.
Password Bypass When enabled, this always prompts for system and internal hard drive
passwords when powered on from the Off state.
By default, the Disabled option is selected.
Password Changes
Allow Non-Admin Password Changes Enables or disables to change system and hard drive password without the
need for admin password.
Default: ON
Admin Setup Lockout
Enable Admin Setup Lockout Enables administrators control over how their users can or cannot access BIOS
setup.
Default: OFF
Master Password Lockout
Enable Master Password Lockout When enabled, this disables the master password support.
Default: OFF
Allow Non-Admin PSID Revert
Enable Allow Non-Admin PSID Revert Controls access to the Physical Security ID (PSID) revert of NVMe hard-drives
from the Dell Security Manager prompt.
Default: OFF
Table 36. System setup options—Update, Recovery menu
Update, Recovery
UEFI Capsule Firmware Updates
BIOS setup 95
96 / 111 95 / 109 96 / 111
To Next Page
Loading...
