Option Description
Default setting: Disabled
NOTE: This feature does not work if you turn off your computer using the
switch on a power strip or surge protector or if Auto Power is set to disabled.
Deep Sleep
Control
Allows you to define the controls when Deep Sleep is enabled.
• Disabled
• Enabled in S5 only
• Enabled in S4 and S5 – This option is enabled by default.
NOTE: This option must be disabled for Wake on LAN feature to work.
Fan Control
Override
Controls the speed of the system fan. This option is disabled by default.
NOTE: When enabled, the fan runs at full speed.
USB Wake
Support
Allows you to enable USB devices to wake the system from Standby.
NOTE: This feature is only functional when the AC power adapter is
connected. If the AC power adapter is removed during Standby, the system
setup removes power from all the USB ports to conserve battery power.
• Enable USB Wake Support
Default setting: The option is disabled.
Wake on LAN/
WLAN
Allows you to enable or disable the feature that powers on the computer from the
Off state when triggered by a LAN signal.
• Disabled
• LAN Only
• WLAN Only
• LAN or WLAN
• LAN with PXE Boot
Default setting: Disabled
Block Sleep This option lets you block entering to sleep (S3 state) in operating system
environment.
Block Sleep (S3 state)
Default setting: This option is disabled
Intel Ready Mode This option enables the capability of Intel Ready Mode technology.
44
To Next Page
Loading...
