Dell OptiPlex 5270 All-in-One - Installing the Memory Module

a) Stand
b) Back cover
3. To locate the memory module on the system board, pry open the DIMM door on the system board shield [1].
4. Pry the retention clips at each end of the memory module slot until the memory module pops up [2].
5. Lift the memory module from the memory module slot [3].
NOTE: Depending on the configuration ordered, your system may have up to two memory modules installed on the
system board.
Installing the memory module
1. Align the notch on the memory module with the tab on the memory module slot, and slide it firmly into the slot at an angle [1].
2. Press the memory module down until it clicks into place [2].
3. Align the tabs on the DIMM door with the slots on the system board shield and snap it into place [3].
26
Removing and Installing components