Installing the pop-up camera
1. Follow the procedure in After working inside your computer.
2. To install the pop-up camera module:
a) Replace the camera module along with the camera cable in the slot on the pop-up camera assembly [1].
b) Snap the pop-up camera assembly in place to the tab [2].
3. To install the pop-up camera bezel:
a) Align the screw slots on the pop-up camera bezel with the screw slots on the pop-up camera assembly [1].
b) Replace the three screws (M3x5) that secure the pop-up camera bezel to the pop-up camera assembly [2].
c) To retract the pop-up camera, press the top of the pop-up camera assembly[3].
Removing and Installing components
47
To Next Page
Loading...
