Steps
1. Remove the 11 screws (M3x5) that secure the middle frame and display-assembly base to the display panel.
2. Place the system in an upright position.
3. Holding the top corner, release the display panel away from the middle frame and display-assembly base.
4. Route the display back-light, touch screen and display cable through the slots on the display assembly base.
5. Lift the display panel up from the middle frame and display-assembly base.
Installing the display panel
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the display panel and provides a visual representation of the installation procedure.
82
Removing and installing components
To Next Page
Loading...
