2. Install the system-board shield.
3. Install the back cover.
4. Install the cable cover (optional).
5. Install the stand.
6. Follow the procedure in After working inside your computer.
Heat sink
Removing the heat sink—UMA
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the stand.
3. Remove the cable cover (optional).
4. Remove the back cover.
5. Remove the system-board shield.
6. Remove the system fan.
About this task
The following image indicates the location of the heat sink and provides a visual representation of the heat sink removal
procedure.
74
Removing and installing components
To Next Page
Loading...
