Dell OptiPlex 7450 All-In-One - Installing Camera Module

Installing camera module
1. Align and place the camera module on the display frame on the computer.
2. Connect the camera cable.
3. Tighten the M3.5x5 screws to secure the camera module to the computer.
4. Install the:
a. chassis frame
b. system board
c. VESA mount bracket
d. speaker
e. OSD board
f. system fan
g. processor
h. heat sink
i. WLAN card
j. SSD card
k. coin cell battery
l. memory module
m. cable cover
n. system board shield
o. hard drive
p. back cover
q. optical drive
r. stand
5. Follow the procedure in After working inside your computer.
48
Disassembly and reassembly