Option Description
NOTE: This feature does not work if you turn off your computer using the switch on a power strip or
surge protector or if Auto Power is set to disabled.
Deep Sleep
Control
Allows you to define the controls when Deep Sleep is enabled.
● Disabled
● Enabled in S5 only
● Enabled in S4 and S5 – This option is enabled by default.
USB Wake
Support
Allows you to enable USB devices to wake the system from Standby.
NOTE: This feature is only functional when the AC power adapter is connected. If the AC power
adapter is removed during Standby, the system setup removes power from all the USB ports to
conserve battery power.
● Enable USB Wake Support
Default setting: The option is disabled.
Wake on LAN/
WLAN
Allows you to enable or disable the feature that powers on the computer from the Off state when
triggered by a LAN signal.
● Disabled
● LAN Only
● WLAN Only
● LAN or WLAN
● LAN with PXE Boot
Default setting: Disabled
Block Sleep This option lets you block entering to sleep (S3 state) in operating system environment.
Block Sleep (S3 state)
Default setting: This option is disabled
Intel Ready Mode This option enables the capability of Intel Ready Mode technology.
POST behavior screen options
Option
Description
Numlock LED Specifies if the NumLock function can be enabled when the system boots. This option is enabled by
default.
Keyboard Errors Specifies whether keyboard related errors are reported when it boots. This option is enabled by default.
Fastboot Allows you to speed up the boot process by bypassing some of the compatibility steps. The options are:
● Minimal
● Through (default)
● Auto
Extended BIOS
POST Time
This option creates an additional pre-boot delay and allows you to see the POST status messages. The
options are:
● 0 seconds (default)
● 5 seconds
● 10 seconds
Full screen Logo This option displays the full screen logo if your image match the screen resolution. The option is disabled
by default.
Warnings and
Errors
This option causes the boot process to only pause when warnings or errors detected. The options are:
● Prompt on Warnings and Errors
● Continue on Warnings
● Continue on Warnings and Errors
64 System setup
To Next Page
Loading...
