5. Remove the hard drive.
6. Remove the system-board shield.
7. Remove the bottom cover.
8. Remove the rear-I/O bracket.
About this task
The following image provides a visual representation of the side-I/O board removal procedure.
Steps
1. Remove the two screws (M3x5) that secure the side I/O-board shield to the display-assembly base.
2. Lift and remove the side I/O-board shield off the side-I/O board.
3. Disconnect the SIO-signal cable, SIO-power cable, and audio-board cable from the system board.
4. Remove the SIO-signal cable, SIO-power cable, and audio-board cable from the routing guides on the display-assembly base.
5. Remove the two screws (M2.5x3.5) that secure the side-I/O board to the display-assembly base.
6. Lift and remove the side-I/O board with cables off the display-assembly base.
72
Removing and installing components
To Next Page
Loading...
