Dell OptiPlex GX110 - Internal View; Front-Panel Inserts

To replace the computer cover, perform the following steps:
1. Check all cable connections, especially those that might have come loose during your work. Fold cables out of the way so that they do not
catch on the computer cover. Make sure cables are not routed over the drive cage—they will prevent the cover from closing properly.
2. Facing the left side of the computer, hold the cover at a slight angle as shown in Figure 2.
3. Fit the cover hooks into the rectangular slots on the chassis. (It might be helpful to look down into the chassis to verify that the hooks are in
place.)
4. Pivot the cover down toward the back and into position. Make sure that the two securing buttons click into place.
Internal View
Figure 3 shows the chassis with the cover removed.
Figure 3. Inside the Chassis
Front-Panel Inserts
Figure4.5.25-Inch Front-Panel Insert Removal
1
Securing buttons (2)
2
Cover hooks (4)
1
Drive in upper bay
2
Internal drive cage
3
Chassis intrusion switch
4
Drive interface cable
5
Expansion-card cage
6
Security cable slot
7
I/O ports and connectors
8
AC power receptacle
9
Padlock ring
10
Power supply
11
System board
12
Drive interface cable