Dell OptiPlex GX110 - Page 39

3.5-Inch Diskette Drive
Figure 11. Removing a Diskette Drive From a Drive Bay
To remove the 3.5-inch diskette drive from the drive bay, perform the following steps:
1. Disconnect the DC power and diskette interface cable from the back of the drive.
2. Press the release tab on the left side of the diskette drive, and pull the diskette drive/bracket out of the chassis.
3. Remove the drive-mountingscrewfromtheleftsideofthedrive,andremovethedrivefromthebracket(seeFigure11).
When you replace the 3.5-inch diskette drive, be sure that the two hooks on the right side of the bracket engage the mounting holes in the side of
the 3.5-inch diskette drive.
5.25-Inch Drive
Figure 12. Removing a 5.25-Inch Drive From a Drive Bay
1
3.5-inch diskette drive
2
5.25-inch drive slots (3)
3
3.5-inch internal bay for hard-disk drives (2)
1
Release tab