Dell PowerConnect 3324 - Page 285

Configuring Switch Information 285
The IGMP Port/LAG Members Table figure displays IGMP Port/LAG member status.
IGMP Port/LAG Members Table
The IGMP Port/LAG Members Table Control Settings Tab le contains the settings for
managing IGMP port and LAG members.
IGMP Port/LAG Members Table Control Settings
Defining ports to receive multicast service:
1 Open the Bridge Multicast page.
2 Define the VLAN ID and the Bridge Multicast Address fields.
3 Toggle a port to S to join the port to a selected multicast group, or Toggle a port to F
to forbid the port from joining that multicast group.
4 Click Apply Changes. The port is assigned to the multicast group, and the device is
updated.
Port Control Definition
D Indicates that the port/LAG has joined the
multicast group dynamically in the Current
row.
S Attaches the port to the multicast group as
static member in the Static Row. Indicates
that the port/LAG has joined the Multicast
group statically in the Current row.
F Indicates that the port is forbidden to join this
multicast group.
Blank Indicates that the port is not attached to the
multicast group.