Dell POWERCONNECT 5548P - Page 268

Dell PowerConnect 55xx Systems User Guide 267
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Maintenance Projects\Dell
Contax\CxUGSystemConfig.fm
DELL CONFIDENTIAL – PRELIMINARY 9/11/12 - FOR PROOF ONLY
Defining Access Profile Rules Using CLI Commands
The following table summarizes the CLI commands for adding rules to access
profiles.
Table 9-41. Access Profiles CLI Commands
CLI Command Description
permit[[gigabitethernet|tengigab
itethernet port-number]|vlan
vlan-id|port-channel LAG-number]
[service service]
Sets port permit conditions for the
management access list.
permit ip-source {ipv4-
address|ipv6-address|prefix-
length} [mask mask|prefix-
length]
[[gigabitethernet|tengigabitethe
rnet][port-number|vlan vlan-
id|port-channel LAG-number]
[service service]
Sets port permitting conditions for
the management access list, and the
selected management method.
deny
[[gigabitethernet|tengigabitethe
rnet] port-number|vlan vlan-
id|port-channel LAG-number]
[service service]
Sets port denying conditions for the
management access list, and the
sel
ected management method.
deny ip-source {ipv4-
address|ipv6-address|prefix-
length} [mask mask|prefix-
length]
[[gigabitethernet|tengigabitethe
rnet] port-number|vlan vlan-
id|port-channel LAG-number]
[service service]
Sets port denying conditions for the
management access list, and the
selected management method.
management access-class
{console-only|name}
no management access-class
Defines which access-list is used as
the active management connections.
Use the no form of this command to
disable management connection
restrictions.