Dell PowerConnect 6224 - Block

1066 Captive Portal Commands
Configured Captive Portals..................... 1
Active Captive Portals......................... 0
Local Supported Users.......................... 128
Configured Local Users......................... 3
System Supported Users......................... 1024
Authenticated Users............................ 0
Captive Portal Configuration Commands
The commands in this section are related to captive portal configurations.
block
Use the block command to block all traffic for a captive portal configuration.
Use the “no” form of this command to unblock traffic.
Syntax
block
no block
Default Configuration
Traffic is not blocked by default.
Command Mode
Captive Portal Instance mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-CP 2)#block